[DRBD-user] Power off caused “Unknown” status.

Your link is very useful, it works now.Thanks. By the way, I changed /etc/drbd.conf like below: (drbd-8.3.0) #after-sb-0pri disconnect;after-sb-0pri “discard-older-primary”; #after-sb-1pri disconnect;after-sb-1pri discard-secondary; I think, for “one node power off” case, “after-sb-1pri discard-secondary; ” will cause power off machine as sync target.By this way, it will avoid “unknown” status.I tested three times, it works. Best regards,Edward > Date: Sat, 11 Apr 2009 13:35:23 +0200> From: r.bhatia at ipax.at> To: guohuai_li at hotmail.com> CC: drbd-user at lists.linbit.com> Subject: Re: [DRBD-user] Power off caused “Unknown” status.> > On 11.04.2009 04:39, guohuai li wrote:> > ue these commands, the logs on machine B are attached.> > > > It shows “Split-Brain detected”.> > > > How to avoid this problem ? And how to restore it to proper status ?> > please refer to> http://www.drbd.org/users-guide/s-resolve-split-brain.html> > cheers,> raoul>

Notes

Leave a Reply

Your email address will not be published. Required fields are marked *